ATMI is specialized in the measurement of liquid level sensors with small diameter or level controllers that are simple to operate: they tilt when the level is too high, which stops or starts the filling of tanks. Some tanks have a very narrow access and it is only possible to measure the level with a detector with a small diameter: omni-directional floats level switches of the liquid level sensors with small diameter TUBA range: tuba 1", tuba 1 ¼ and tuba 125 C.
Their tubular shape has been designed to enter small access into tanks or cisterns. These liquid level sensors with small diameter can be installed in three ways: on a vertical rod, with ballast on a cable or on the wall of the tanks with a gland. The tuba detectors can be used for several applications: liquids level detection, automatic pump controls, high and low level alarms.
A high level of water can be detected when the water has reached the float level switches placed at the chosen high level. The liquid will push the detector which will stop the filling of the pumps through contact with the electrical panel.
28/01/2025 + How to avoid a tank overflowing? Level detectors & controllers
 Tanks are often used to make or store liquid products. To prevent a tank from overflowing it is necessary to have specific equipment: level... |
17/01/2025 + ACS Sanitary Conformity Certification ATMI
In France, since December 24th 2006, any device or accessory in contact with drinking water meant human consumption must be ACS certified (ACS =... |
02/07/2024 + Float Level Switches Advantages
ATMI offers a wide range of float level switches (simply designed for an easy installation) that ensure safe installations in a multitude of... |
06/06/2024 + Aggressive Liquids - Measure the Level
Measurement of the level of aggressive liquids must be done with suitable equipment. ATMI offers float level switches and regulators of very high... |
22/05/2024 + Grains and cereals - How to measure the level of a silo ?
To know the level of cereals - Oat, wheat, soybean, sunflower, corn, stallions, rice, barley - or grains contained in a silo, try the SOLIBA... |
22/06/2017
- Tilt level switches for very light powders
ATMI proposes a range of tilt level switches that are specially adapted for powder: SOLIBA SPECIAL and SOLIBA SPECIAL EX for explosive areas. They... |
12/05/2017
- Capture the level of liquids with floats
Float level switches are a simple and effective solution for capturing fluid level. ATMI offers a wide range of floats level switches that are... |
18/04/2017
- Safe level measurement of liquids and solids - Accessories
ATMI is specialized in solids and liquids level measurement. In order to have a safe and accurate control of the quantity of liquids and solids, ATMI... |
14/04/2017
- To regulate the level of drinkable water – SOBA EP
The SOBA EP tilt level switch is ACS certified. It means that it can be used in drinkable water. By tilting when the level is high it can activate or... |
05/04/2017
- To measure the level of a solid - Explosive area
The devices used to measure the level of cereals, powders, feed, grain in a silo or container must be Atex certified. Atmi suggest you the SOLIBA EX... |
29/03/2017
- Soba range – Omnidirectionnal liquids level regulators
To regulate the level of a liquid in a tank or in a cistern, ATMI advice you to use two SOBA omnidirectional level regulators for the wanted high and... |
21/03/2017
- Liquids detection & regulation with a narrow access Tuba Range
Description TUBA float level switches have been designed to control and regulate the level of various liquids in tanks and cisterns with a narrow... |
13/03/2017
- SOLIBA a simple and reliable solids level measurement
Soliba is a mechanical solids level technology based on a very simple system. It is suspended vertically. When the solid in the silo has reached the... |
06/01/2017
- Four float level switches ranges for liquids
If you are looking for a float level switch to do all types of automatic regulations of liquids level (automation) for pumps of all powers and for... |
25/12/2016
- Optimize your level measurement with accessories
Specialised in the conception of systems to measure and regulate liquids and solids level with floats and tilt level switches, ATMI recommends you... |
13/12/2016
- Very resistant floats for agressive mixtures
In some industry sectors, aggressive liquids are frequently used: chemical, pharmaceutical, oiland gas, and shipping. To measure and control their... |
10/12/2016
- Liquids and solids levels - detection and regulation
A large range of floats and tilt level switch is proposed by ATMI to detect, regulate the level and stop the filling of different liquids and solids... |
25/11/2016
- Solid tilt level switches: atex certification
To evaluate the level of solids such as grains, powder and bulk solids. ATMI offers you different solution.You can choose either a standard model or... |
01/11/2016
- Float switches for narrow access tanks & cisterns
To measure the level of liquids when the access is etheir difficult or narrow, ATMI has conceived the Tuba range of float switches that are designed... |
21/10/2016
- Water and agriculture technology - AgWatec Spain 2016
AgWatec exhibition on Agriculture and Water technology will be held from November 7th to 9th in Seville (in Spain). The purpose is to promote the... |
|
+33 (0)1 61 37 35 60
sales@atmi.fr